Powers

3/16" x 1-1/4" 410 Stainless Steel Hex Tapper Concrete Screw, 100/Box

(No reviews yet) Write a Review
SKU:
CSHS316114;P
UPC:
075352141800
MPN:
4180
Availability:
In Stock / Ships Today
$212.26

Description

Products Features 
  • TESTED IN ACCORDANCE WITH ASTM E488:  Quality and tested hold values provide for a successful fastening
  • NO HOLE SPOTTING REQUIRED:  Fasten item to be attached in place saving time and effort
  • DOES NOT EXERT EXPANSION FORCES:  Allows for screws to be placed closer to one another
  • HIGH-LOW THREAD DESIGN:  Fastener installation requires less torque which leads to an easier installation process
Products specifications 
Bit Size 5/32"
Box Qty 100
Minimum Embedment 1"
Head Type  Hex Washer
Thread Type  Hi-Lo
Minimum Edge Distance 2-1/4"
Maximum Fixture Thickness 1/4"
Minimum Fixture Hole Diameter (In Place) 1/4"
Minimum Fixture Hole Diameter (Hole Spotted) 1/4"
Driver Size 1/4"
Minimum Spacing 3"
Thread Length 1-1/4"
Length Measurement  Underneath head
Diameter 3/16"
Length 1-1/4"
Material 410 Stainless Steel Silver Climaseal® Coated
Environment  Moist
Type  Male
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Application Video 

Installation Video 

Installing a 3/16" x 1-1/4" 410 Stainless Steel Hex Tapper Concrete Screw

  1. Drill a 5/32" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
  2. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of 1" is met.
  3. The hole can be drilled while the fixture is in place. The minimum hole in the fixture for the 3/16" x 1-1/4" 410 Stainless Steel Hex Tapper Concrete Screw is 1/4".
  4. Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
  5. Insert the point of the 3/16" x 1-1/4" 410 Stainless Steel Hex Tapper Concrete Screw into the hole. Make sure that the screw being installed will penetrate the base material a minimum of 1" but no deeper than 1-3/4".
  6. Using a 1/4" nut driver Phillips bit tip for the anchor , turn the screw clockwise, applying slight pressure until the head of the screw is snug against the material being fastened.
  7. Always use proper personal protective equipment per manufacturer's and OSHA instructions.

View AllClose

Additional Information

Bit Size:
5/32"
Minimum Embedment:
1"
Thread Length:
1-1/4"
Environment:
Moist
Material:
410 Stainless Steel Silver Climaseal® Coated
Thread Type:
Hi-Lo
Type:
Male
Diameter:
3/16"
Length:
1-1/4"
Box Qty:
100
Minimum Spacing:
3"
Minimum Edge Distance:
2-1/4"
Maximum Fixture Thickness:
1/4"
Minimum Fixture Hole Diameter (In Place):
1/4"
Minimum Fixture Hole Diameter (Hole Spotted):
1/4"
Head Type:
Hex Washer
Length Measurement:
Underneath head
Driver Size:
1/4"
View AllClose

Related Products

Related Products