CONFAST®

1/4" x 3" Stainless Steel Hammer Drive Anchor, 100/Box

(No reviews yet) Write a Review
SKU:
HDS143
UPC:
820274003640
Availability:
In Stock, Ships Today!
$123.53

Description

Products Features 
  • INSTALLS IN A VARIETY OF BASE MATERIALS:  Can be used in a variety of applications; job will be easier and faster 
  • MUSHROOM​ ​HEAD:  Lager bearing​ ​surface provides improved pullover characteristics 
  • ANCHOR DIAMETER IS HOLE DIAMETER:  Creates easily determined hole size for simple application process 
  • ALL SIZES PACKAGED 100 PIECES PER BOX:  Standardized quantity amount for purchase planning and usage 
  • PERMANENT​ ​FASTENING:  Once installed, fastener cannot be removed; very secure 
Products specifications 
Bit Size  1/4" 
Box Qty  100 
Minimum Embedment  3/4" 
Head Type  Mushroom 
Minimum Edge Distance  1-1/4" 
Maximum Fixture Thickness  1-1/4" 
Minimum Fixture Hole Diameter (In Place)  5/16" 
Minimum Fixture Hole Diameter (Hole Spotted)  5/16" 
Brand Name  CONFAST® 
Minimum Spacing  2-1/2" 
2000 PSI Concrete - Pull-Out (lbs.) *  405 
2000 PSI Concrete - Shear (lbs.) *  450 
Length Measurement  Underneath head 
Diameter  1/4" 
Length  3" 
Material  Zamac body - 304 Stainless steel nail 
Environment  Wet 
Type  Male 
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Installation Video 
Installing a 1/4" x 3" (three inches) Stainless Steel Hammer Drive Anchor 
  1. Drill a 1/4" hole into the concrete using a carbide tipped bit that meets ANSI Standards B212.15. 
  2. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of 3/4" is met. 
  3. The hole can be drilled while the fixture is in place. The minimum hole in the fixture for the 1/4" x 3" (three inches) Stainless Steel Hammer Drive Anchor is 5/16". 
  4. Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb. 
  5. Insert the 1/4" x 3" (three inches) Stainless Steel Hammer Drive Anchor, slit end first, through the material to be fastened and into the hole, ensuring that the bottom of the head is sitting flush with the fixture plate. 
  6. Hammer the nail flush into the head of the anchor body. 
  7. Always use proper personal protective equipment per manufacturers and OSHA instructions. 

View AllClose

Additional Information

Bit Size:
1/4"
Minimum Embedment:
3/4"
Type:
Male
Material:
Zamac body - 304 Stainless steel nail
Environment:
Wet
2000 PSI Concrete - Pull-Out (lbs.) *:
405
2000 PSI Concrete - Shear (lbs.) *:
450
Diameter:
1/4"
Length:
3"
Box Qty:
100
Minimum Spacing:
2-1/2"
Minimum Edge Distance:
1-1/4"
Maximum Fixture Thickness:
1-1/4"
Minimum Fixture Hole Diameter (In Place):
5/16"
Minimum Fixture Hole Diameter (Hole Spotted):
5/16"
Head Type:
Mushroom
Length Measurement:
Underneath head
Brand Name:
CONFAST
View AllClose