CONFAST®
3/8" CONFAST Threaded Rod Anchor for Wood, Vertical, 1/4" x 2", 100/Box
- SKU:
- TRAW38V142
- Availability:
- In Stock, Ships Today!
Description
Products Features
- No pre-drilling required – self tapping screw save time of installation
- Install in center of wood member provides best opportunity for highest holding values
- Fast Installation – save time from traditional methods
- Special nut driver – prevents shearing of fastener saving time and money
- One piece design – reduces installation cost
Products specifications
Box Qty | 100 |
Diameter | 1/4" |
Length | 2" |
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Diameter of Anchor
The diameter of the anchor is 1/4".
Length Anchor
The length of the anchor is 2"
Installing a 3/8" CONFAST Threaded Rod Anchor for Wood, Vertical, 1/4" x 2"
- Insert the correct nut driver into a 3/8” or 1/2” drill motor.
- Insert the CONFAST® Threaded Rod Hanger into the nut driver.
- Push the fastener vertically into the surface of the base material while the drill rotates.
- Installation is complete once the nut driver spins freely. Nut driver is designed to cam out once the fastener is secured.
Note:
- Maximum RPM for installation is 1200. Do not install the fastener while the drill motor is in the hammer or impact mode, doing so will Destroy holding values.
- Minimum Size of Wood Member not less than 2" nominal wide and 3" nominal height