CONFAST®

1/4" x 1-1/2" Split Drive Round Zinc Plated, 100/Box

(No reviews yet) Write a Review
SKU:
SDR14112
UPC:
820274001875
Availability:
Contact us for information, see page for alternatives.
$24.22

OUT OF STOCK

Description

Products Features 
  • TAMPERPROOF:  Anchor cannot be removed; provides security for item being attached 
  • FLAT​ ​COUNTERSUNK HEAD:  Ideal for fastening wood to concrete where head of the anchor sits flush with surface of the wood 
  • NO SPECIAL TOOLS NEEDED:  Drill the hole drive with a hammer; fast and simple 
  • ONE DIAMETER AND SEVEN LENGTHS:  Wide selection options will meet most application requirements 
  • WIDE RANGE OF LENGTHS:  The right fastener for the correct application 
Products specifications 
Bit Size 1/4" 
Box Qty 100 
Minimum Embedment 1-1/8" 
Head Type Round Head 
Primary Concrete only 
Minimum Edge Distance 1-1/4" 
Maximum Fixture Thickness 3/8" 
Minimum Fixture Hole Diameter (In Place) 3/8" 
Brand Name CONFAST® 
Minimum Spacing 2-1/2" 
2000 PSI Concrete - Pull-Out (lbs.) * 990 
2000 PSI Concrete - Shear (lbs.) * 1248 
Length Measurement Underneath head 
Diameter 1/4" 
Length 1-1/2" 
Material Carbon Steel Zinc Plated 
Environment Dry 
Type Male 
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load
Installation Video 
Installing a 1/4" x 1-1/2" Split Drive Round Zinc Plated 
  1. Drill a 1/4" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15. 
  2. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of 1-1/8" is met. 
  3. The hole can be drilled while the fixture is in place. The minimum hole in the fixture for the 1/4" x 1-1/2" Split Drive Round Zinc Plated is 3/8". 
  4. Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb. 
  5. Insert the 1/4" x 1-1/2" Split Drive Round Zinc Plated through the material to be fastened and into the hole, ensuring that the bottom of the head is sitting flush with the fixture plate. 
  6. Hammer the anchor until the head of the anchor is tight against the item being fastened. 
  7. Always use proper personal protective equipment per manufacturer's and OSHA instructions. 

View AllClose

Additional Information

Bit Size:
1/4"
Minimum Embedment:
1-1/8"
Type:
Male
Primary:
Concrete only
Environment:
Dry
2000 PSI Concrete - Pull-Out (lbs.) *:
990
2000 PSI Concrete - Shear (lbs.) *:
1248
Diameter:
1/4"
Length:
1-1/2"
Material:
Carbon Steel Zinc Plated
Box Qty:
100
Minimum Spacing:
2-1/2"
Minimum Edge Distance:
1-1/4"
Maximum Fixture Thickness:
3/8"
Minimum Fixture Hole Diameter (In Place):
3/8"
Head Type:
Round Head
Length Measurement:
Underneath head
Brand Name:
CONFAST
View AllClose