3/4" American Made Drop-In Anchor Zinc Plated, 25/Box
Availability:
In Stock / Ships Today
Questions?
MFG:
American Made ThunderDrop®
Required To Install:
3/4" Drop-In Setting Tool, Each
Products Features
- STAMPED WITH "USA": Meets most requirements of Made in America
- SMOOTH ANCHOR BODY: Provides excellent and consistent holding values in concrete
- INTERNAL NATIONAL COARSE THREADS: Most common threads makes locating threaded rod or bolt fast and easy
- PRECISION CUT EXPANSION END: Provides for uniform expansion during the installation process
- NO LIPPED ANCHOR DESIGN: Anchor can be installed at a depth deeper than the anchor body length to provide opportunity for greater holding values
Products specifications
Bit Size
|
1"
|
Minimum Embedment
|
3-3/16"
|
Thread Type
|
3/4" - 10
|
2000 PSI Concrete - Pull-Out (lbs.) *
|
6678
|
Type
|
Female
|
Primary
|
Concrete only
|
Diameter
|
3/4"
|
Length
|
3-3/16"
|
Material
|
Carbon Steel Zinc Plated
|
Environment
|
Dry
|
Box Qty
|
25
|
Minimum Spacing
|
10"
|
Minimum Edge Distance
|
5"
|
Minimum Fixture Hole Diameter (In Place)
|
1-1/8"
|
Minimum Fixture Hole Diameter (Hole Spotted)
|
3/4"
|
Maximum Torque
|
80 ft./lbs.
|
Inside Anchor Diameter-Bolt Diameter
|
3/4"
|
Outside Anchor Diameter
|
1"
|
Internal Thread Length
|
1-3/8"
|
Length Measurement
|
End to End
|
Bolt Length
|
Fixture Thickness + Embedment Depth
|
Country
|
American Made
|
Brand Name
|
ThunderDrop
|
Application Video
Installation Video
Installing a 3/4" American Made Drop-In Anchor Zinc Plated- Drill a 1" hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
- The depth of the hole can be deeper or equal to the minimum embedment depth of 3-3/16" which is equal to the length of the anchor .
- Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
- Insert the anchor into the hole with the open threaded end facing up.
- Take the correct 3/4" American Made Drop-In Anchor Zinc Plated setting tool and insert the smaller diameter end into the threaded portion of the 3/4" American Made Drop-In Anchor Zinc Plated.
- Strike the end of the setting tool with a hammer until the anchor is fully set.
- The 3/4" American Made Drop-In Anchor Zinc Plated is now set. A 3/4" diameter threaded rod or a bolt can be inserted into it with a maximum torque of 80 ft./lbs.
- Always use proper personal protective equipment per manufacturer's and OSHA instructions.
Product Reviews
* The figures above indicate average ultimate tension and shear failure values. A safety factor of 4:1 or 25% of ultimate value is generally accepted as a safe working load. Reference should always be made to applicable codes.
* The bits are recommended by diameter and may not necessarily be the length needed for your application. Please make sure the usable length will work for your application. *