CONFAST®

5/8" American Made Drop-In Anchor 316 Stainless Steel, 25/Box

(No reviews yet) Write a Review
SKU:
ADIS31658
Availability:
In Stock, Ships Today!
$1,083.27

Description

Products Features 
  • COMPLETE ​LINE:  Ensures ​correct ​product ​can ​be ​located ​and ​purchased ​for ​any ​job 
  • ALL ​LENGTHS ​ARE ​AVAILABLE:  Using ​the ​correct ​length ​screw ​ensures ​quality, ​secure ​fastening 
  • SPECIAL ​THREADS: Decreases ​installation ​torque ​allowing ​screw ​to ​be ​installed ​faster and ​easier 
  • TWO​ ​DIAMETERS:  ​3/16" ​and ​1/4" Choice ​allows ​for ​wider ​variety ​of ​fastening ​applications depending ​on ​the ​hole ​in ​the ​fixture ​being ​attached 
  • BIT ​INCLUDED ​IN ​EACH​ ​BOX:  Using the correct ​bit ​will give you ​better-​holding ​values 
Products specifications
Box Qty 25
* Values shown are average ultimate values and are offered only as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally accepted as a safe working load

Applications
The anchor is made from . This anchor is designed for use in

Depth of Hole
The depth of the hole that is required for the anchor should be a minimum of 1/2" deeper than the anchor will penetrate the concrete. This will allow space for dust created during the installation process to fall, which will prevent the anchor from bottoming out in the hole before full penetration into the concrete.

Installing a 5/8" American Made Drop-In Anchor 316 Stainless Steel
  1. Drill a hole into the concrete using a carbide-tipped bit that meets ANSI Standards B212.15.
  2. Drill the hole a 1/2" deeper than the anchor will penetrate the concrete, making sure the minimum embedment requirements of 1" is met.
  3. Clean the hole with a wire brush, vacuum, compressed air, or a blow-out bulb.
  4. Insert the point of the 5/8" American Made Drop-In Anchor 316 Stainless Steel into the hole. Make sure that the screw being installed will penetrate the base material a minimum of 1" but no deeper than 1-3/4".
  5. Turn the screw clockwise, applying slight pressure until the head of the screw is snug against the material being fastened.
  6. Always use proper personal protective equipment per manufacturer's and OSHA instructions.

View AllClose

Additional Information

Box Qty:
25
Bit Size:
7/8"
Minimum Embedment:
2-1/2"
Thread Length:
1-3/16"
Thread Type:
5/8" - 11
2000 PSI Concrete - Pull-Out (lbs.) *:
3323
Type:
Female
Primary:
Concrete only
Diameter:
5/8"
Length:
2-1/2"
Environment:
Submerged/Chemicals
Minimum Spacing:
8-3/4"
Minimum Edge Distance:
4-3/8"
Minimum Fixture Hole Diameter (In Place):
1"
Minimum Fixture Hole Diameter (Hole Spotted):
5/8"
Maximum Torque:
40 ft./lbs.
Length Measurement:
End to End
Brand Name:
ThunderDrop
Material:
316 Stainless Steel
View AllClose